Project

General

Profile

Forums » Req. Waijung 1 Tech Support »

Encoder Read block error

Added by Anonymous over 3 years ago

Error using encoder read block to measure DC motor speed. The error message is attached i keep getting this error in simulink i am quite new to this software does anyone know how to solve

236545505_1015980465869240_4519693314946852328_n.jpg View 236545505_1015980465869240_4519693314946852328_n.jpg 52.2 KB

Replies (3)

RE: Encoder Read block error - Added by Dhanika Mahipala (ดานิก้า) over 3 years ago

Hello thamonwan,

Thank you for using our Waijung block set. It might be helpful if you could mention the following details about your system setup;
  1. The target microcontroller
  2. The Matlab version

In addition would you please be able to attach the model file that causes this error?

Dhanika

RE: Encoder Read block error - Added by Anonymous over 3 years ago

Used controller: FiO 2
Matlab version : R2018a
waijung version : waijung17_03a

RE: Encoder Read block error - Added by Dhanika Mahipala (ดานิก้า) over 3 years ago

Hello thamonwan,

Can you please attach the Simulink model file (.slx file) that is causing this error?

Dhanika

    (1-3/3)