Project

General

Profile

An error occurred in Auto compile and download process. Please refer the log data above.

Added by Ayoub Ezzine 7 months ago

Hello,

i´m testing now Waijung2 with the STM32L476RG Nucleo using a simple simulink model (attached). But the build process terminates always with an Error (attached).

I will make Screenschots about Description of the STM32 that i used from the STM32 ST-Link utility, so you can betterf recognize where the problem is.

The Device flash Size is only 1MBytes, but the Target setup block is supporting only Hardware cards from 4 MBytes !! is this the problem maybe ??

Thank´s

Ayoub

Simulink Model.JPG View Simulink Model.JPG 34 KB the simulink model
StlinkUtilkity.JPG View StlinkUtilkity.JPG 161 KB ST-Link Utility
targetSetup.JPG View targetSetup.JPG 58.6 KB Target Setup parameters
diagnistic viewer.JPG View diagnistic viewer.JPG 159 KB Diagnostic viewer
Error.JPG View Error.JPG 70 KB The Error message

Replies (1)

RE: An error occurred in Auto compile and download process. Please refer the log data above. - Added by Dhanika Mahipala (ดานิก้า) 7 months ago

Hello Ayoub,

Thank you for you interest on our products.

Currently we have two Waijung products available for users namely :
  1. Waijung 1 for STM32 MCU family.
  2. Waijung 2 for the ESP32 MCU family.

You are trying to use Waijung2 (built for ESP32) to generate code for an STM32 board. Hence the build process terminates. If you specifically want to use a STM32 board, you have to opt for Waijung1. However, currently Waijung1 does not support STM32L476RG microcontroller.

If you are not constrained to a specific microcontroller for your application, you could consider using an ESP32 board which is supported by Waijung2.

Best regards,
Dhanika

    (1-1/1)