Project

General

Profile

Forums » Req. WJ2(Zynq-7000) support »

Error message in digital input block

Added by Johan Henning almost 2 years ago

When configuring the digital input, an error pops up. After clicking the error away the configuration dialog for the digital input block pops up.

clipboard-202302061009-rhlnf.png View clipboard-202302061009-rhlnf.png 35.3 KB

Replies (2)

RE: Error message in digital input block - Added by martin van beek almost 2 years ago

Hi Johan,
Do you've the model, because I don't get that error message.
Did you placed the target setup block, and select a Vivado hardware reference design with 'inputs' connected/defined?
Success and best regards,

Martin.

RE: Error message in digital input block - Added by Johan Henning almost 2 years ago

Hi Martin,
It does not happen any more. As far as I remember I started with putting a Digital Input block on an empty canvas, then double clicked it and then the error message popped up. But I did not save the model. I will do so if it happens again.
Regards!
johan.

    (1-2/2)