Project

General

Profile

Forums » Req. WJ2(Zynq-7000) support »

Error message in digital input block

Added by Johan Henning 10 months ago

When configuring the digital input, an error pops up. After clicking the error away the configuration dialog for the digital input block pops up.

clipboard-202302061009-rhlnf.png View clipboard-202302061009-rhlnf.png 35.3 KB

Replies (2)

RE: Error message in digital input block - Added by martin van beek 10 months ago

Hi Johan,
Do you've the model, because I don't get that error message.
Did you placed the target setup block, and select a Vivado hardware reference design with 'inputs' connected/defined?
Success and best regards,

Martin.

RE: Error message in digital input block - Added by Johan Henning 10 months ago

Hi Martin,
It does not happen any more. As far as I remember I started with putting a Digital Input block on an empty canvas, then double clicked it and then the error message popped up. But I did not save the model. I will do so if it happens again.
Regards!
johan.

    (1-2/2)